Connecting Remote Sensors - Bresser ClimaTemp FSX Mode D'emploi

NOTE
9.
10. When you change the relative atmospheric pressure
11. The built-in barometer can notice the environmental ab-
12. The relative atmospheric pressure is based on the sea

18 Connecting remote sensors

The Weather Station can display the readings from up to 3
wireless sensors* of the same type. Each radio sensor must
be set to a separate channel. Proceed as follows to set the
channel:
1.
2.
3.
4.
18 / 108
The default relative atmospheric pressure value is 1013
mb/hPa (29.91 inHg), which refers to the average at-
mospheric pressure.
value, the weather indicators will change along with it.
solute atmospheric pressure changes. Based on the
collected data a forecast for the weather conditions in
the next 12 hours can be made. Therefore, the weather
indicators will change according to the detected abso-
lute atmospheric pressure after you operate the clock
for 1 hour.
level, but it will change with the absolute atmospheric
pressure changes after operating the clock for 1 hour.
Remove the battery compartment cover of the wireless
sensor.
Set the channel selection switch to the desired channel
(CH1, CH2 or CH3).
Re-attach the battery compartment cover.
NOTICE! Each connected wireless sensor must be set
to a different channel. If only one wireless sensor is
connected, it should be set to CH1.