Placing Your Child In The Maxi-Cosi Mura; General; Adjusting The Length Of The Belt; Adjusting The Height Of The Shoulder Belt - Maxi-Cosi Mura 3 Mode D'emploi

5 PLACING YOUR CHILD IN THE
MAXI-COSI MURA

5.1 General

- Note: always set the brake on the Maxi-Cosi Mura
before placing your child in the seat. Ensure that the
safety harness is open.
1. Slide the buckle sections together and click them into the
buckle. The lap belt and the shoulder belts are fastened
to the crotch strap (Fig. 32).

5.2 Adjusting the length of the belt

1. Unfasten the Velcro on the Comfort cushion from the
back rest. Unfasten the shoulder belt hook and remove
the belt pad (Fig. 33).
2. Adjust the belt length to the size of your child by
lengthening or shortening the clasp (Fig. 34).
3. Place the belt pads over the shoulder belts again. Attach
the hooks to the loop. Slide the belt pad up over the
shoulder belt and attach it using the press-stud (Fig. 35).
4. Push both buttons to open the belt buckle (Fig. 36).

5.3 Adjusting the height of the shoulder belt

1. Unfasten the shoulder belt hook and remove the belt pad
(Fig. 37).
2. Pull the shoulder belt out of the loop and thread it
through the other loop (Fig. 38).
3. Adjust the belt length to the size of your child by
lengthening or shortening the clasp (Fig. 39).
4. Place the belt pads over the shoulder belts again. Attach
the hooks to the loop. Slide the belt pad up over the
shoulder belt and attach it using the press-stud (Fig. 40).
EXI0275_Mura_3_I_BW.indd 11 EXI0275_Mura_3_I_BW.indd 11

6 CLEANING AND MAINTENANCE

Warning
- Check regularly to make sure that the Maxi-Cosi Mura
functions properly. This is essential for your child's safety.
- For reasons of safety, always use original parts.
- In the event of damage have your retailer check and/or
repair your Maxi-Cosi Mura before using it again.
- When cleaning never use silicon lubricants. These attract
dirt and grime.
- Clean the frame, the fabric cover and the basket regularly
using a damp cloth. Do not use abrasive cleaners.
6.1 General
- During rain always use the rain cover to protect the fabric
cover. After use, dry the pushchair with a soft, absorbent
cloth.
- Remove the detachable wheels once a month, clean the
axles and lubricate them with a dry Tefl on spray.
- Never use the Maxi-Cosi Mura in seawater. After use on
the beach, clean the frame and wheels thoroughly with
water to prevent rusting.
6.2 Cleaning the Maxi-Cosi Mura Comfort cushion
1. Remove the Maxi-Cosi Mura seat from the frame.
2. Remove the T-bar.
3. Unfasten the shoulder belt hook and remove the belt
pads.
4. Loosen the fabric cover on the footrest (Fig. 41).
5. Slide the tabs on the bottom of the cushion outwards
(Fig. 42). The Comfort cushion will now be free of the
seat.
6. Remove the belt pad from the crotch strap by loosening
the snap.
7. Loosen all loops on the bottom of the seat (Fig. 43).
8. Remove the fabric cover from the Comfort cushion. Start
on one side and continue on the other side (Fig. 44).
- Note! Remove the fabric cover around the T-bar aperture
last (Fig. 45)!
9. Finally, pull the safety harness fully out of the Comfort
cushion.
11
21-07-09 12:06 21-07-09 12:06