Folding And Disassembling; Removing The Wheels - Maxi-Cosi Mura 3 Mode D'emploi

Locking the swivel wheels
1. Press the swivel lock on the wheel down and turn the
front wheel to the rear position until you hear a 'click'
(Fig. 19).
2. To release the lock lift up the swivel lock.
Maxi-Cosi Mura sun canopy
Attaching the sun canopy
1. Attach the clips on to the tubes on the sides of the seat
backrest. Make sure the holes in the clips snap over the
buttons. Place the top of the clip over the tube fi rst and
then push the bottom until it 'clicks' into place (Fig. 20).
Using the sun canopy
2. Fold open or close the sun canopy using the lever (1)
(Fig. 21). To release the sun canopy, pull the levers on
both sides slightly outwards. Adjust the sun canopy into
the desired position and 'click' it into place (Fig. 22/23).
3. When using the backrest in the fl at or reclining position,
the extra sun fl ap under the sun canopy can also be used.
Pull the fl ap up and outwards (Fig. 24).
Basket
1. The basket can be used for shopping up to a maximum of
5 kg (Fig. 25).
2. You can attach and remove the basket using the press
studs, hooks and elastics (on the bottom of the Maxi-Cosi
Mura).
- Note: do not exceed the maximum permitted weight of
5 kg!

4.2 Folding and disassembling

Folding
1. If you want to fold the Maxi-Cosi Mura with the seat still
attached, this is only possible when the seat is attached
in the forward-facing position and the back rest is in the
extreme forward position (Fig. 26).
- We recommend that the seat is always removed before
starting to fold the pushchair.
2. Fold back the sun canopy parallel to the handlebar
(Fig. 21).
3. Turn the fold safety lock on the right side downwards
and then simultaneously pull the folding-up release
buttons on both sides upwards (Fig. 27).
4. Tilt the handlebar forwards and then down until it 'clicks'
into the transport lock (Fig. 28).
10
EXI0275_Mura_3_I_BW.indd 10 EXI0275_Mura_3_I_BW.indd 10
If you want to fold the frame even smaller
5. Remove the seat before starting folding.
6. Turn the front wheel forward.
7. Press the release button (Fig. 29).
8. The frame folds even smaller.
9. Remove the wheels if necessary.

Removing the wheels

1. Rear wheels: press on the centre of the hubcap and at the
same time pull the rear wheels out of the frame (Fig. 30).
2. Front wheel: press in the release button and pull the front
fork out of the frame (Fig. 31).
21-07-09 12:06 21-07-09 12:06