Publicité
Les langues disponibles
Les langues disponibles
GENERAL INSTRUCTIONS.-
This exercise machine is equipped with a dynamo that makes use of the energy produced by the user (while
exercising) to power the electronic monitor and the brake controller.
This monitor screen is touch sensitive, so to press a key just place your finger on the said key displayed on
the screen.
This exercise machine also includes a set of batteries that store enough energy to keep the electronic
monitor operating for 60 seconds after the exercise has finished.
Should the battery run down because of an operational fault, it can be recharged by using the adapter that is
supplied with the exercise machine.
To switch the monitor on, start exercising.
ATTENTION:
The adapter should be plugged into an appropriate socket. Make sure that the main voltage is
compatible with the voltage for the adapter supplied with the machine.
The electronic monitor is designed to be easy and intuitive to use. The messages that appear on the bottom
screen (B) will guide the user throughout the whole exercise.
Nevertheless, we recommend that a gym instructor reads through this section carefully to become fully
familiar with the electronic monitor in order to show the user how to operate it correctly.
IMPORTANT: TO ENSURE THAT THE BATTERIES OPERATE CORRECTLY AND LAST LONGER IT IS
ADVISABLE TO RECHARGE THEM USING THE ADAPTER SUPPLIED WITH THE MACHINE.
PERSONALIZING THE ELECTRONIC MONITOR.-
From the main menu, press both the RESET key and the "0" button for 6 seconds. The words "FACTORY –
SETTINGS" will appear on the alphanumeric screen (B), Fig.1:
Press "8" and select the software from the chart below:
Press "2" and select the machine type E (elliptical), B / R (Bike / Recumbent) or S (Stepper) with LEVEL ▲
and ▼ keys.If you wish to exit the personalization mode press the STOP key.
Follow the steps below to access the monitor's personalization mode: From the main menu, press both the
RESET key and the "0" button for 6 seconds. The words "FACTORY – SETTINGS" will appear on the
alphanumeric screen (B), Fig.1, press "ENTER".
1) CHANGING FROM Kilometers to Miles.-
The word UNITS will appear, press the ENTER key and the word METRIC will flash, select the unit of speed
by using the LEVEL▲ LEVEL▼ keys (METRIC / Km. -- ENGLISH / Miles) press the ENTER key. The word
"UNITS" will start flashing. To set the Distance per Revolution/Wheelsize use the LEVEL ▲ key to navigate to
the "WHEELSIZE" menu. (Step 2) If you wish to exit the persnalization mode, press the STOP key and the
manual program will be displayed on the LED array (A).
2) CHANGING DISTANCE PER REVOLUTION.-
With the word "WHEELSIZE" flashing, press the ENTER key and a figure between 0 - 80 will start flashing.
Select the value using the LEVEL▲ LEVEL ▼ keys (models H800, H895, G930 select 80) press the ENTER
key. The word "WHEELSIZE" will start flashing. To set the language use the LEVEL ▲ key to navigate to the
"LANGUAGE" menu. (Step 3) If you wish to exit the personalization mode press the STOP key.
ENGLISH
BH300
BH200-YL
BH200-DK
E1
H800, H895, G930, R250, ST1000
H720, H775, G818, BR1000,
BU1000, EC1000
G815
G824, G825
15
SK
LINE
sportkoncept
Publicité
