Fisher Scientific Isotemp FBG Serie Manuel D'utilisation page 16

Table 3. Power Cord Specification
Model Power Cord Specifications
A 3-G 12 AWG, NEMA
5-15P, 15 A/125 V
D 3-G 14 AWG, NEMA
6-15P, 15 A/250 V
CAUTION: Risk of Shock. Never cut
the grounding prong from the service
cord plug. If the prong is removed, the
warranty is invalidated.
In an emergency, the power cord is a
disconnect device.
Shelves
Single door laboratory refrigerators come standard with 4
full shelves and double door laboratory refrigerators come
standard with 8 full shelves.
Maximum shelf capacity is 45 kg (100 lbs).
For safety in shipping, the shelves are packaged and
secured inside the cabinet. Insert the shelf support
hangers (included inside the unit) into the built-in shelf
supports (located on the inside walls of the cabinet interior)
at the desired locations. Position the shelves on the flat
supports (refer to Figure 5). If you have a Pharmacy model,
do not position shelving where it will disrupt the thermal
bottle and probe assembly.
Figure 3. Shelf Support Hanger
16
Baskets
Pharmacy models ship with baskets installed. 12 cubic foot
Pharmacy models ship with 5 baskets, 23 and 30 cubic foot
Pharmacy models ship with 6 baskets, and 50 cubic foot
Pharmacy models ship with 12 baskets.
Baskets are shipped in a factory installed position that
promotes uniform spacing between the baskets. The baskets
slides are adjustable to higher and lower positions in the
cabinet. You can position these slides in the vertical slots
which are spaced at one-inch intervals. The baskets must be
removed in order to adjust the position of the basket slides.
For FBG1205P, FBG2305P, and FBG5005P, the maximum
basket capacity is 27 kg (60 lbs). For FBG3005P, the
maximum basket capacity is 36 kg (80 lbs).
Installation Instructions
WARNING: Do not to move this unit
while loaded
1. Determine proper locations for shelf clips- the reference
number on the pilaster can serve as a guide to ensure all
clips are properly located and even.
2. Insert the top of the shelf clip into the desired hole of the
plaster- the retaining tab should be facing upwards.
3. Rotate the shelf clip downwards and insert the bottom
tab into the appropriate hole in the pilaster. Note that the
clip may need to be squeezed slightly during installation in
order to fit.
4. Install shelves onto clips with the product retention bar
facing upwards. Be careful not to dislodge clips during
shelf installation.
5. Prior to loading the shelf, ensure that the shelf is resting on
each of 4 clips and the clips are installed.
CAUTION: Improper shelf clip installation
may cause shelf and/or product damage to
the unit.
CAUTION: Do not overload the shelves,
the unit is designed to utilize all shelves
that are supplied in an equally spaced
manner.