8.5.5 New Job
Following completion of the cutting job, a buzzer sounds
and the statement shown is displayed.
REPEAT:
INPUT MODE:
Should the next job be identical to the previous one, just
press the <START> key and the cycle begins again, as
before first with a control cut.
Should the next job require different parameters, press the
<CLR> key and the display reverts to Input Mode.
8.6
Manually Operated Cutting
8.6.1 Material Feed
To provide a material feed which overrides the
programmed parameters simply press the <
material is then fed at a speed of 50mm./sec. for so long
as the key is pressed.
8.6.2 Single Cut
A press of the <
> key provides a cutting cycle without
material feed.
By pressing the <
> key and the <
lengths of material can be cut independant from any
programming.
The <
> key and the <
> key can be used in the
following situations;
-
before entering the cutting parameters
-
before and after completing the test cut
-
before each programmed cutting assignment, with
or without a batch quantity
-
after each programmed single cut
<START>
< CLR >
> key. The
> key, a length, or
8.5.5 Nouvelle commande
Après l'achèvement de toutes les coupes programmées,
un signal sonore retentit et l'utilisateur est informé.
REPETER:
MODE REGLAGE:< CLR >
Si la nouvelle commande est identique à la précédente
presser sur la touche <START> et le cycle peut
recommencer immédiatement par une coupe échantillon.
Si la nouvelle commande requiert des paramètres
différents, presser la touche <CLR> et l'écran retourne à
la phase de réglage des paramètres de coupe.
8.6
Coupe manuelle
8.6.1 Avance de matière
Pour réaliser une avance de matière sans tenir compte
des paramètres programmés, presser la touche <
matériau est alors avancé à la vitesse de 50 mm/sec.
pendant toute la durée de pression de cette touche.
8.6.2 Coupe coup par coup
Une pression de la touche <
des couteaux sans avance de matière. Ainsi une coupe
simple après l'introduction de matière est possible.
En pressant la touche <
>, puis la touche <
possible de couper des longueurs de matière
indépendamment de toute programmation.
Les touches <
> et <
> sont conseillées dans les
situations suivantes:
- avant la séléction des paramètres de coupe
- avant et après l'éxecution de la coupe échantillon
- avant chaque coupe programmée, avec ou sans lot
- après chaque coupe coup par coup programmée.
<START>
>. Le
> permet un mouvement
> il est
43