Ergomotion quest 2.5 Manuel Du Propriétaire page 9

installation guide
Always use two people when setting up the base.
Remove the bed base from the box keeping the bottom of the
1
base facing upwards.
• Untwist the mattress retainer bar from the frame and set aside.
• Legs are shipped fully assembled. Alternative heights in 3"
increments can be achieved by removing leg segments.
• To install the legs, thread the washer over the bolt of the leg
with the recessed side facing the leg, and tighten by hand.
Do not over tighten.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
2
Flip the base & connect the cables.
• Uncoil the Input Cord (connected to control
box's Power port) and plug it into the Power
Supply.
• Carefully flip the base over on to its legs.
Important: Two people are required to move the bed base. Do not
drag across the floor. Do not rest frame on its side, excessive pressure
may damage the legs.
• Insert the Power Cord into the Power
Supply.
• Plug the Power Cord into a power outlet. A
surge protector is recommended.
7