Ergomotion quest 2.5 Manuel Du Propriétaire page 16

remote control pairing & child lock
Remote Control Pairing
The original remote that comes in the box is already paired to the adjustable
base. No further action is required. In the event that the remote is not paired
with the base, follow the steps below.
1
Unplug the Power Cord from your power outlet. Wait 1 minute, then plug
it back in to your power outlet. Perform Step 2 within 10 seconds, while
the control box light is flashing.
Power Supply
2
Press and hold down the Pair button. The LED light
on the remote will start flashing. When the LED stops
flashing, the illuminated light on the Control Box will
go out. Release the Pair button. The remote is now
paired to the adjustable base.
3
Test all remote functions. If the remote buttons do not impact the
adjustable base movements, please repeat the process again or call
Ergomotion® customer service: 1-888-550-3746
14
Power Cord
Child Safety Lock
This remote control is programmed with a child-lock safety feature. Follow the
instructions below to lock or unlock the remote control.
ACTIVATE CHILD LOCK
Press and hold FLAT and HEAD UP buttons
for three (3) seconds. When the backlight
on the remote flashes twice, the lock is
completed. If any button is pressed while
under the lock status, the backlight on the
remote will flast twice.
DEACTIVATE CHILD LOCK
Press and hold FLAT and FOOT UP buttons
together for three (3) seconds. When the
backlight on the remote flashes twice, the
unlock is completed and the remote will
work normally.