Ergomotion quest 2.5 Manuel Du Propriétaire page 5

safety precautions and usage statements
WEAR AND TEAR:
Wear and tear is damage that naturally and inevitably occurs as a result of normal use
or aging.
FABRIC CARE:
To prolong the life of your fabric, protect from direct sunlight whenever possible.
For spot cleaning, wipe area with a light damp sponge or vacuum with a soft brush
attachment to remove particles. Keep at a minimum of 30cm (12 inches) away from
direct heat sources. For a deeper cleaning, blot liquid spills with a clean dry cloth. Wipe
with a clean cloth dampened with warm water. Do not wet excessively. A soft bristle
brush may be used to remove ingrained soil. Avoid scratching by gentle brushing. Wipe
with a clean cloth dampened with warm water to remove residues. Dry in shade away
from direct heat. If persistent marks remain visible after cleaning, seek professional
advice.
PRODUCT RATINGS:
The lift motors are not designed to operate continuously for more than [2] minutes in
an [18] minute time period or approximately 10% duty cycle. Attempting to circumvent
or exceed this rating will shorten the life expectancy of the product and may void the
warranty. The massage motors are not designed to operate continuously for more
than 30 minutes at a time. Please allow the massaging system to rest for 30 minutes
after automatic massage shut off before restarting.
WEIGHT LIMITS:
This product is not rated to support weights in excess of 750 pounds. The base will
structurally support this weight, provided it is evenly distributed across the bed base.
The adjustable base is not designed to support or lift this amount in the head or foot
sections alone. Exceeding this weight restriction could damage the bed and/or cause
injury and will void the warranty.
FCC COMPLIANCE:
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
SAVE THESE INSTRUCTIONS.
3