Maintenance; General; Daily Cleaning - Hatco Toast-Qwik TQ3 Série Manuel D'installation

MAINTENANCE

General

Hatco Toast-Qwik Conveyor Toasters are designed
®
for maximum durability and performance with minimum
maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Put unit in standby, allow to cool, turn OFF power
switch, and unplug power cord before performing
cleaning, adjustments, maintenance, or attempting to
clear a jam.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• Do not allow liquids to spill into unit.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some after-market or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.

Daily Cleaning

To preserve the finish of the unit, it is recommended that the
metal surfaces be wiped daily with a damp cloth.
Submerging or saturating unit with water will damage the
unit and void unit warranty.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
1. Perform the "Daily Shutdown" procedure in the
OPERATION section, and unplug the power cord.
BURN HAZARD: Do not remove feed ramp, crumb tray, or
toast tray for cleaning until toaster is cool.
2. Remove and clean the crumb tray, removable toast tray
(TQ3-400 only), and toast tray insert (if equipped).
a. Wash the crumb tray and toast trays with warm water
and a mild detergent. Rinse with water.
b. Allow the crumb tray and toast trays to air dry.
3. Wipe the exterior surfaces of the toaster with a non-
abrasive, damp cloth.
• Stubborn stains may be removed with a good stainless
steel cleaner or a non-abrasive cleaner. Hard to reach
areas should be cleaned with a small brush and mild
soap.
4. Clear all crumbs from the expandable toast tray and wipe
clean.
5. Wipe dry the entire unit using a soft, non-abrasive cloth.
6. Reinstall the crumb tray, removable toast tray (TQ3-400
only), and toast tray insert (if
a. Position the crumb tray directly below the conveyor belt
on the tray floor at the front of the toaster.
b. Slide the crumb tray into the toaster until it stops.
Installing the Crumb Tray
12
English
WARNING
NOTICE
CAUTION
equipped).
Form No. TQ3M-0519