Adjusting Automatic Powersave; Changing Control Settings - Hatco Toast-Qwik TQ3 Série Manuel D'installation

English

Adjusting Automatic PowerSave

Use the following procedure to enable/disable the automatic
PowerSave feature as well as make adjustments to its settings.
1. Touch the icon on the Menu Screen. A password
screen will appear.
• Enter the 3-digit password "248".
The Service screen will appear.
2. Touch POWERSAVE on the
Service screen. The Automatic
PowerSave screen will appear.
3. Make the desired adjustments on
the Automatic PowerSave screen.
• Touch ON to enable automatic
PowerSave. Touch OFF to
disable automatic PowerSave.
• Heat: Touch the
next to the Heat percentage to
change the heat output level of the elements during
PowerSave mode.
• Time: Touch the
to change the number of minutes of inactivity required
before automatic PowerSave is activated.
4. When all adjustments are done, touch EXIT to return to
the Service screen, then EXIT again to return to the Menu
Screen.
Form No. TQ3M-0519
Service
Firmware
Control
Testmode PowerSave
Version
Automatic PowerSave
On Off
Heat
47 %
Time 9 mins
or arrow
EXIT
or arrow next to the Time value

Changing Control Settings

Use the following procedure to make changes to control access
privileges and toaster operation.
1. Touch the
screen will appear.
• Enter the 3-digit password "248".
The Service screen will appear.
Usage
2. Touch CONTROL on the Service
screen. The Control Settings
screen will appear.
Exit
3. Make the desired adjustments on
the Control Settings screen.
• Touch ON or OFF to enable or
disable each of the operational
settings shown on this screen.
• Passcode: Enable this setting
to require a password to make
changes to menu item settings.
• ColorGuard: Disable this setting to turn off the ColorGuard
System, as described in the MODEL DESCRIPTIONS
section of this manual.
• Logo: Enable this setting to put the toaster into a single
setting, "always on" mode.
4. When all changes are done, touch EXIT to return to the
Service screen, then EXIT again to return to the Menu
Screen.
11
OPERATION
icon on the Menu Screen. A password
Service
Firmware
Control
Testmode
Version
Control Settings
Passcode
ColorGuard
Logo
Usage
PowerSave
Exit
On Off
On Off
On Off
EXIT