Operating The Toaster - Hatco Toast-Qwik TQ3 Série Manuel D'installation

English

Operating the Toaster

Startup
1. Plug the unit into a properly grounded electrical receptacle.
Make sure the electrical receptacle matches the plug on the
unit and the supply voltage matches the unit specification
label.
2. Move the toast feed ramp to the desired position.
• For automatic feeding, move the toast feed ramp to
the automatic feed position. Bread products enter the
toaster by placing them on the toast feed ramp and
releasing.
• For manual feeding, rotate the toast feed ramp up until
it rests on top of the unit. Bread products can be loaded
manually by placing directly on the conveyor belt.
Automatic
Feed Position
Toast Feed Ramp
3. Move the Power I/O switch located
on the back of the unit to the "I" (on)
position.
• Logo and software version
information will appear on the
touchscreen, followed by the
Standby screen.
NOTE: If the touchscreen goes dark
after turning on the power, touch anywhere on the
touchscreen to "wake up" the display.
4. Touch and hold the
touchscreen for three seconds to
activate the toaster.
• The preheating cycle will begin
and last approximately 10
minutes. When preheating is
complete, the conveyor belt will
start moving, and the Menu screen will appear showing
the available menu items.
5. Touch the desired menu item icon
on the touchscreen.
• A blue square will outline the
selected menu item.
• The elements and conveyor
belt will adjust settings to the
selected menu item.
• Use the blue arrow keys to scroll between screens of
available menu items.
Form No. TQ3M-0519
Manual
Feed Position
Power I/O
Switch
icon on the
Unit is off
Cooling fan may still operate
TQ3-900H
SWTQ900HHA0113
NAME NAME
NAME NAME
1/3
Toast Feed
Ramp
Warning
Light
Toast
Slide
Touchscreen
Control
Model TQ3-500 Conveyor Toaster
6. Place bread product onto the toast feed ramp.
7. Change the toasting shade at any
time during toasting. To change:
a. Touch the icon. The Toast
Shade screen will appear.
b. Touch the or
five times to produce a shade
lighter or darker than the current menu item setting.
8. Change the selected menu item at any time by touching
the desired menu item icon on the touchscreen.
• Use the blue arrow keys to scroll between screens of
available menu items.
NOTE: For TQ3-500, TQ3-900, and TQ3-2000 models: If the
Warning light on the control panel comes on, the unit
may be overheating due to fan failure/blockage. Turn
off and unplug the unit. Contact an Authorized Service
Agent or Hatco for assistance.
Standby Shutdown
Use standby shutdown to put the toaster in standby during
extended periods of non-use.
1. Touch and hold the
touchscreen for one second to shut
down operation and put the toaster
into standby.
• The heating elements and
conveyor will shut down.
• The cooling fans will run until the unit is cool.
Shutdown
1. Touch and hold the
second to shut down operation and put the toaster into
standby.
2. After the cooling fans stop, move the Power I/O switch
located on the back of the unit to the "O" (off) position to
turn off the toaster. NOTICE: Do not turn off unit while
cooling fans are running. Damage to unit may occur.
9
OPERATION
Crumb
Tray
Expandable
Toast Tray
icon up to
Lock On Off
icon on the
Unit is off
Cooling fan may still operate
TQ3-900H
SWTQ900HHA0113
icon on the touchscreen for one
USB
Port