Installation Of The "Unibox Rla Vario; Installation Of The "Unibox Rla Vario" In The Supply Pipe - oventrop Unibox RLA vario Notice D'utilisation

Unibox RLA vario
1
2
3
4
5
6
7
Illust. 5: Installation cross section
(1)
Block or stud wall
(2)
"Unibox RLA vario"
(3)
Plaster
(4) Pipe conduit unit (separate accessory)
(5) Edge insulating strip (separate acces-
sory)
(6) Screed
(7) Protective tube (separate accessory)
6.2 Installation of the "Unibox RLA
vario"
To guarantee a perfection operation of the
"Unibox RLA vario", the direction of flow must
be strictly observed when installing the pipe-
work and the installation sets "Unibox".
6.2.1 Installation of the "Unibox RLA
vario" in the supply pipe
For the isolation of the supply pipe, install
the "Unibox RLA vario" in front of the surface
heating circuit/surface temperature regulation
circuit as shown in the installation example in
Illust. 6. Install the "Unibox T", "Unibox RTL",
"Unibox E RTL" or "Unibox T-RTL" behind the
surface heating circuit/surface temperature
regulation circuit.
102272680-V01.04.2020
1
Illust. 6: Installation example "Unibox RLA
vario" with "Unibox T"
(1) "Unibox RLA vario"
(2) "Unibox T" (operation with "Unibox
RTL", "Unibox E RTL" and "Unibox
T-RTL" is also possible)
(3)
Supply
(4) Return
1. Remove the protection cover of the "Uni-
box RLA vario" (you must refit the protec-
tion cover after commissioning).
2. Provide a branch from the supply pipe of
the two pipe heating system.
3. Place the "Unibox RLA vario" into the wall
at the desired location.
Use a pipe conduit unit to facilitate
installation.
4. Connect the "Unibox RLA vario" to the
branch.
Observe the marked flow direction.
5. Lay the surface heating circuit/surface
Installation
2 4
3
21