Publicité
Les langues disponibles
Les langues disponibles
Operation
Changing/inserting the tool/collet
chuck
♦
Press the spindle lock
♦
Turn the tensioning nut
into place.
♦
Undo the tensioning nut
using the combination spanner
♦
Remove any attached tool.
♦
First push the intended tool through the tensioning
nut
before inserting it into the appropriate
collet chuck
for the tool shaft.
♦
Press the spindle lock
♦
Push the collet chuck
and screw the tensioning nut
combination spanner
Using an accessory tool with a mandrel:
♦
Use the screwdriver side of the combination
spanner
to undo and tighten the screw on
the mandrels
or
♦
Insert the respective mandrel
the appliance as described.
♦
Use the combination spanner
screw on the mandrel
♦
Insert the desired accessory tool between the
two washers on the screw.
♦
Use the combination spanner
screw on the mandrel
│
GB │ IE
■
28
and hold it down.
until the lock clicks
from the thread
.
and hold it down.
into the thread insert
tight with the
.
.
,
or
into
to undo the
or
.
to tighten the
or
.
Whet stone
♦
Do not manually grind any edges with the whet
stone
.
Fitting abrasive belts
♦
Push the abrasive belt
mandrel
. Tighten the screw on the abrasive
belt mandrel
in order to fix the abrasive belt
.
Fitting polishing attachments
♦
Screw the polishing attachment
of the mandrel for polishing attachments
Switching on and off/setting speed
range
CAUTION!
■
The rotation direction can be read off the
arrow engraved on the union nut
clockwise symbol).
Switching on/setting the speed range:
♦
Set the ON/OFF switch
♦
Set the infinitely variable speed control
a position between "1" and "MAX".
Switching off:
♦
Move the ON/OFF switch
"O".
onto the abrasive belt
onto the tip
.
(anti-
to the "I" position.
to
to the position
PFBS 160 B2
Publicité
