Publicité
Les langues disponibles
Les langues disponibles
[ss ]
Correct handling of machine
WARNING:
Attachment of shoulder strap
e Adjust the strap length so that the cutter blade or the nylon ct
ting head will be kept parallel with the ground.
Detachment
eIn an emergency, pull the release belt (1) strongly upward, ar
you can detach the machine from you, Be extremely cautions
maintain control of the machine at this time. Do not allow tt
machine to be deflected toward you or any one in the work vicinit
Failure to maintain complete control of the machine at all could result in serious bodily injury or DETAIL.
Putting into operation
Observe the applicable accident prevention regulations!
Starting
ei
Cold start
For machine with U Handle or J Handle
è Push the stop switch (1) in the direction shown by the arrow.
e Grasp the handle (hand pressure activates the safety lock-off lev
(5).
|
e Press the throttle lever (6) and hold it down.
e Press the lock button (4) and release the throttle lever, and the
release the lock button (the lock button holds the throttle lever
the start-up poition).
For machine with loop handle
e Push the stop switch (9) in the direction shown by the arrow.
e Squeeze the throttle lever (7) fully.
e Hook the lock fin (14) to the notch (13) in the throttle lever ca:
while releasing the throttle lever.
Publicité
