Makita RBC220 Manuel D'instructions page 12

Mounting of handle
(12)
(14)
(13)
12
e Connect the throttle wire and firmly close the cable joint.
e Squeeze the throttle lever to make sure that the throttle wiren
smoothly.
e Connect the switch cords to the two cords from the engir
inserting one into the other.
e Insert the bullet connectors (10) through the holes in the cove
For machines with U handle
e Loosen the handle installation bolts (12).
e insert the handle into the handle joint (13) fully.
+ After making sure that the handle is installed properly, tighte
installation bolts (12) to secure the handle.
e Secure the throttle wire with the clip wire (14) as shown in the
for easy operation.