Publicité
Les langues disponibles
Les langues disponibles
Assembling of engine and drive shaft
r
10
CAUTION:
Before doing any work on the brush cutter or the grass trimme
always switch off the motor and pull the spark plug connector o
the spark plug. Always wear protective gloves!
CAUTION:
Start the brush cutter or the grass trimmer only after havin
assembled it completly.
e Insert the nuts M5 (1) into the hex holes in the holder case. Inse
the screws M5 x 30 (2) through the opposite holes and semi-tighte
the screws M5 x 30.
e Insert the nipple (3) of the throttle wire through the square hol
in the grip until it fits into the square hole in the moving part whic!
is inside the grip. It should move
when the throttle lever i
squeezed.
e Insert the shaft into the holder case fully untill the grip end reache:
the holder case while passing the throttle wire and the switch cord
(4) through the slot in the holder case.
NOTE:
Match the square drive of the inner shaft to the square hole ins
the holder case by slightly rotating the drive shaft or the suppor
washer on the head case, and you can insert the drive shaft int
the holder case smoothly.
E
Be cautions not to allow the switch cords to be pinched betweet
the holder case and the grip end.
e Match the hole in the holder case to the hole in the inner shaf
and insert the screw M65 x 8 through the holes. Then tighten
t h i
screw M5 x 8 and the screws M5 x 30 (5).
NOTE:
Squeeze the throttle lever to make sure that the throttle wire mo
smoothly.
e Connect the switch cords to the two cords from the engine
inserting one into the other. Insert them through the holes in t
cover (6).
Publicité
