Publicité
Les langues disponibles
Les langues disponibles
Screen alarm
ALARM FAIL
SYSTEM FILE
ALARM FAIL
MAINTENANCE
ALARM RELAY
OVERLOAD
ALARM RELAY
MAX-MIN
ALARM DIGITAL
INPUT A
NON PRIOTARY
LOADS DISCONNEC.
Tabla 9. Available alarm list depending on the model.
Screen 4.2
Selection of the language of the LCD panel messages: English,
French, Catalan and Spanish.
Screen 4.3
Setting of MODBUS address of the equipment and Baud rate.
Screen 4.4
Reading the input nominal voltage.
Screen 4.5
Reading the output nominal voltage.
Screen 4.6
Output voltage set point setting in %. This setting modifies the
preset nominal output voltage to a higher or lower value.
Screen 4.7
Output voltage accuracy setting, which can be adjusted be-
tween 0,5 and 5 %.
Screen 4.8
Analogical control selection. When selecting «YES» the output
voltage will be set between a minimum and maximum voltage
range according to the 0...10 V reference voltage input setting.
Screen 4.9
Access to the setting screens of the equipment when it is im-
plemented an upgraded firmware from version 104. By means
of the screen 4.9, the selected voltages done in the installation
menu can be changed and corrected the wrong selections or
even to set the equipment for a new installation.
USER'S MANUAL
Enabling
Description
Parameter system not coherent.
Notification of needing for
preventive maintenance.
Overload relay activated because
the load is higher than 100 %.
Maximum-minimum relay
activated because it is out of
range.
The external digital output has
been activated.
Non-critical load level has been
exceeded.
The voltage values that the end-user will be able to select in
level
the setting menu for a single or three phase structure and high
or low voltage will depend in the constructive features of the
Any.
equipment.
Any
Any different value from the standard setting is already set
from factory, so the screens to select the input and output volt-
(3).
ages will not be available in the installation menu. It is under-
stood as NON STANDARD, those voltage values different from
(4).
the ones stated in the screen 4.4, because under request the
equipments can be manufactured with other voltages with their
respective LCD panel metering.
(5).
(6).
7.3.6. «Password» menu.
To access from main screen press 5 times the move forward
«
» key. By means of the «
ferent screens of its submenus, being able to move freely from
one to another by means of the «
Screen 5.1
Access to the screens protected by password. T.S.S. staff has
only access to these screens.
» key there is access to the dif-
» or «
» keys.
EMi3 SERVOMOTOR VOLTAGE STABILISER
75
Publicité
