Publicité
Les langues disponibles
Les langues disponibles
11.
Remove the rear tires as shown in
Note:
Retain all wheel components for later
installation.
12.
Remove the pod brackets from the machine
(Figure
3).
Note:
Retain the shoulder screws removed
from the sides of the pods for later installation.
1. Hydraulic mount plate
2. Screw
Figure
Figure 2
Figure 3
3. Pod support bracket
4. Pod
2.
2
Installing the ROPS Mounts
Parts needed for this procedure:
1
Left ROPS mount
1
Right ROPS mount
6
Bolt (1/2 x 1-1/4 inches)
6
Large washer
6
Locknut (1/2 inch)
Procedure
1.
Install the ROPS mounts to the machine frame
g466421
behind the hydraulic mount plate.
2.
Torque the bolts to 91 to 113 N∙m (67 to 83 ft-lb).
3.
Secure the tabs on the pods to the ROPS mount
with narrow push rivets
1. Locknut (1/2 inch)
2. Right ROPS mount
g310040
3. Narrow push rivet
4
(Figure
4).
Figure 4
Right side shown
4. Large washer
5. Bolt (1/2 x 1-1/4 inches)
g316031
Publicité
