Toro 79682 Instructions D'installation page 12

5
Completing the Installation
Parts needed for this procedure:
1 ROPS tube
2 Bolt (3/8 x 2-1/2 inches)
2 Locknut (3/8 inch)
Suitcase weight (For machines with a bagger installed
3
only)
2 Bolt (3/8 x 3-3/4 inches)
Procedure
1. Install the rear tires as shown in
2. Lower the machine; refer to your machine
Operator's Manual.
3. Lower the seat.
4. With the ROPS tube angle toward the front of
the machine, install the ROPS tube to the ROPS
mounts with 2 bolts (3/8 x 2-1/2 inches) and 2
locknuts (3/8 inch) as shown in
5. For machines with a bagger installed only:
Install the included additional suitcase weights
to the machine using 2 bolts (3/8 x 3-3/4 inches)
as necessary according to the table below
(Figure 13).
Type of Deck
42-inch fabricated deck
54-inch fabricated deck
Figure 2.
Figure 12.
Total Weights Required
8
8
1. ROPS tube
2. Locknut (3/8 inch)
1. Washer
2. Locknut
10
Figure 12
3. Bolt (3/8 x 2-1/2 inches)
Figure 13
3. Suitcase weight
4. Bolt (3/8 x 3-3/4 inches)
g310259
g299244