User Servicing And Maintenance Instructions; Cleaning; Grease Filter - Elica ETP536SS Guide D'utilisation, D'entretien Et D'installation

User Servicing and Maintenance Instructions

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical
supply by switching off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be
removed from the socket.

Cleaning

The cooker hood should be cleaned regularly
(at least with the same frequency with which
you carry out maintenance of the fat filters)
internally and externally. Clean using the
cloth dampened with neutral liquid detergent.
Do not use abrasive products. DO NOT USE
ALCOHOL!
WARNING: Failure to carry out the basic
cleaning recommendations of the cooker
hood and replacement of the filters may
cause fire risks.
Therefore, we recommend oserving these
instructions.
The manufacturer declines all responsibility
for any damage to the motor or any fire
damage linked to inappropriate maintenance
or failure to observe the above safety
recommendations.

Grease Filter

Traps cooking grease particles.
The grease filter must be cleaned once a
month using non aggressive detergents,
either by hand or in the dishwasher, which
must be set to a low temperature and a short
cycle. When washed in a dishwasher, the
grease filter may discolour slightly, but this
does not affect its filtering capacity.
The metal grease filter and the carbon filter
are installed coupled at the bottom
(extraction area).
To remove or refit them, proceed as follows:
a+c. turn the three screws 1/4 turn.
b+d+e. remove the filter holder frame and
the metal grease filter (and the carbon filter).
Proceed in reverse order to refit.
19