User Servicing And Maintenance Instructions; Cleaning; Grease Filter; Replacing The Light Bulb - Elica EGL436S1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

User Servicing and Maintenance Instructions

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical
supply by switching off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be
removed from the socket.

Cleaning

The cooker hood should be cleaned regularly
(at least with the same frequency with which
you carry out maintenance of the fat filters)
internally and externally.
cloth dampened with neutral liquid detergent.
Do not use abrasive products. DO NOT USE
ALCOHOL!
WARNING: Failure to carry out the basic
cleaning recommendations of the cooker
hood and replacement of the filters may
cause fire risks.
Therefore, we recommend oserving these
instructions.
The manufacturer declines all responsibility
for any damage to the motor or any fire
damage linked to inappropriate maintenance
or failure to observe the above safety
recommendations.

Grease Filter

Traps cooking grease particles.
The filters should be washed frequently
using non aggressive detergents, either by
hand or in the dishwasher, which must be set
to a low temperature and a short cycle.
When washed in a dishwasher, the grease
filter may discolour slightly, but this does not
affect its filtering capacity.
To remove the grease filter, pull the spring
release handle.
Clean using the
18

Replacing the light bulb

Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs
ensure they are cooled down.
Use a small screwdriver as a lever on the
borders of the lamp in order to remove
the lightbulb.
Slide out the lightbulb to be replaced and
replace with a new 12V 20W MAX 30°
Ø35 12V GU4.
Carry out the replacement and mount the
new lightbulb by following instructions in
the reverse.
If the lights do not work, make sure that the
lamps are fitted properly into their housings
before you call for technical assistance.

Publicité

Table des Matières
loading

Table des Matières