Velleman CAMCOLD 25 Notice D'emploi page 5

4. Guide the power and video cable [9] through one of the cable
slots [8] and fix the mounting plate [1] on the ceiling or wall
with four screws.
5. Insert the lens enclosure [4] in the positioning ring [3] and slide
the fixation ring [2] over both. Point the camera towards the
desired field of observation and screw the fixation ring [2] back
on the mounting plate [1].
6. Connect the video connector [A] to a monitor (not incl.) or a
sequential switcher/quad splitter (not incl.) when connecting
multiple domes.
7. Connect the power connector [B] to a 12VDC power supply (not
incl.)
7. OSD Settings
Control Buttons
There is a small joystick in the camera cable that allows you to
adjust the settings of the camera using an on-screen display (OSD).
In the OSD menu:
 NEXT/BACK: select this option and press the button to go to the
next/previous page of options in the menu.
 RETURN: select this option and press the button to return to the
previous level in the menu.
 EXIT: select this option and press the button to leave the OSD
menu without saving the settings.
 SAVE&EXIT: select this option and press the button to save all
settings.
 LOAD DEFAULT: select this option and press the middle button to
reset the camera to the factory defaults.
 SOFT VERSION: displays the version number of the camera
software.
The OSD menu settings are described in detail below.
V. 01 – 17/06/2014
CAMCOLD25
 Press and hold the button during
± 2 seconds to access the menu, or press
briefly to select an option.
 Press the button upward and downward to
move up and down in the menu.
 Press the button to the left and to the right
to modify the menu parameters.
5 ©Velleman nv