Publicité
1. Locknut
1. Contre-écrou
1. Contratuerca
2. Adjusting nut
2. Écrou de réglage
2. Tuerca de ajuste
3. Loosen the locknut on the brake cable.
4. Turn the adjusting nut on the brake cable in
direction a to increase the cable length or in
direction b to decrease the cable length.
NOTE:
_
If the cable cannot be adjusted to specification,
consult a Yamaha dealer.
_
5. Tighten the locknut on the brake cable.
6. Screw in the adjusting bolt at the rear brake
caliper until it feels tight, and then screw it out
1/8 turn. Tighten the locknut to the specified
torque.
Tightening torque:
Locknut:
16 Nm (1.6 m·kgf)
8-61
Publicité
