Publicité
Les langues disponibles
Les langues disponibles
Operation
Fitting/changing the saw blade
Always remove the battery pack before changing
the saw blade
!
1. Set the cutting depth (using the locking screw
to the minimum position, 0 mm.
2. Press the spindle lock button
es) and hold it in.
3. Undo the tensioning screw
4. Now, remove the tensioning screw
clamping flange
Fig. A: Changing the saw blade
5. Pull the blade guard
the release lever
in this position.
6. Remove the saw blade
appliance from below.
7. Fitting a saw blade
order.
8. Press the spindle lock button
and use the hex key
screw
.
WARNING!
►
The arrow on the saw blade
spond to the arrow showing the direction of
rotation
(running direction shown on the
blade guard
).
■
Ensure that the saw blade
rotational speed of the tool.
PHKSA 12 A2
(until it engag-
using a hex key
and the
(see also fig. A).
all the way back using
and keep the blade guard
carefully out of the
is done in the reverse
(until it engages)
to tighten the clamping
must corre-
is suitable for the
Rip fence
♦
Undo the wing screw for the rip fence
place the rip fence
♦
Set the desired cut width
using the scale on the rip fence
)
out in the base plate
The right recess in the base plate is for a cutting
angle of 0°.
.
Fig. B: Cutting width 2 cm
♦
Retighten the wing screw for the rip fence
Connecting a dust extraction unit
♦
Attach the adapter for dust extraction
chip ejector
Optional depending on the diameter of the dust
and sawdust extraction.
♦
Connect an approved dust and chip extraction
device.
NOTE
►
When sawing wood or other materials that
create dusts that are hazardous to health,
always connect the appliance to a suitable,
certified suction appliance.
Use
Switching on and off
Switching on:
♦
Push the safety lock-out
and keep it pressed.
♦
Press the ON/OFF switch
light
lights up. Once the saw is running, you
can release the safety lock-out
Switching off:
♦
Release the ON/OFF switch
in the rip fence slot
and the cut
(see also fig. B).
.
to the left or right
. The LED work
.
.
GB │ IE
and
.
.
to the
│
25
■
Publicité
