Publicité
Les langues disponibles
Les langues disponibles
(1)
(2)
(3)
(4)
(6)
1.
Insert the angle shim (5) in one of the two possible settings into the clean stem (4). This results in the angle of the stem of -12°
or -17°.
2.
Insert the angle spacer (6) into the stem in the appropriate orientation.
3.
Coat the cleaned and grease-free clamping surfaces of the stem with assembly paste and place the stem on the steerer tube.
The assembly paste increases the desired frictional force between the components to be assembled so that the screw
tightening torque does not have to be higher than necessary.
4.
To mount the stem, loosen the stem bolts (4) slightly and attach the stem including the angle shim (5) and angle spacer (6) to
the steerer tube. Make sure that the stem protrudes at least 2 mm to allow the Ahead cap to be fitted.
5.
If brake cables and/or shift cables are to be routed through the stem, route them through the openings in the stem in advance
according to one of the three variants illustrated below.
(5)
Publicité
