Publicité
Les langues disponibles
Les langues disponibles
Note
For the protection of third parties, a component that is not immediately and obviously recognizable as defective should be clearly
marked as unusable.
Mounting
Mounting of the Stem
Warning
Incorrectly mounted components
Improperly mounted components can cause a crash.
•
You must read and understand the instructions and notes before you begin installation.
•
If you have questions about the installation of these components, contact your SQlab dealer or have the stem installed by
an experienced mechanic at your SQlab dealer.
Note
For the equipment of an eMTB, eBikes and pedelecs, country-specific standards, rules and regulations must be observed.
•
In Germany, observe the "Guide for Modifications to Pedelecs" of the Zweirad-Industrie-Verband e.V. (http://www.ziv-
zweirad.de) in cooperation with Verbund Service und Fahrrad g.e.V. (www.vsf.de) and Zedler-Institut für Fahrradtechnik und
-Sicherheit GmbH (www.zedler.de).
•
SQlab saddles are not approved across the board for fast pedelecs (S-pedelecs, up to 45 km/h). Please observe the country-
specific requirements. In Germany, the "Guidelines for component replacement on fast e-bikes/pedelecs with pedal
assistance up to 45 km/h" must be observed in particular.
The SQlab stems are designed for mounting on all conventional steerer tube with a clamping diameter of 28.6 mm. The minimum
clamping height of the stem must not be less than 30 mm.
Before mounting, carefully read the user information of the stem and the add-on components to be attached to the handlebar (shift and
brake levers, grips, remote levers, etc.). If there are any questions, doubts or conflicting specifications, ask your SQlab specialist dealer
for advice before mounting.
In addition to basic knowledge of assembly and mechanics, the tool specified by the stem (usually a 4 mm or 5 mm Allen key) and an
appropriate torque wrench are required to fit the stem.
Publicité
