GYS KRYPTON 401 DC TRI Mode D'emploi page 36

User manual
• Tack (Mode adjustable directly from the welding cycle)
This welding mode also allows for the pre-assembly of workpieces before wel-
ding, but in two stages this time: the first phase is pulsed DC to concentrate the
arc for better penetration, followed by a second phase in standard DC to widen
the arc, and therefore the weld pool, to ensure the spot.
The adjustable times of the two phases allow for better repeatability and non-oxi-
dised points.
Spot
VaL
Welding
time
pulse (s)
Spot
VaL
welding time
(s)
• Multi-Tack (Mode adjustable directly from the welding cycle)
This is a tacking mode similar to TIG Tack, but with defined spot and hold times
for as long as the trigger is held down.
Spot
VaL
Welding
time
pulse (s)
Spot
VaL
welding time
(s)
36
Translation of the original
instructions
The tacking time is in the welding cycle after the gas station.
t.PL Man
t.dC Man
t.PL Man
t.dC Man
KRYPTON 231 DC FV / 321 DC TRI / 401 DC TRI
SETUP
PRESS 3''
The grayed-out areas are not available in this mode.
60.0
t.PL
60.0
t.dC
SETUP
PRESS 3''
The grayed-out areas are not available in this mode.
t.PL 60.0
60.0
t.dC
Weld
t.PL
t.dC
Validation of
the current
setting
Weld
t.PL
t.dC
Validation of
the current
setting
JOB
JOB