GYS KRYPTON 401 DC TRI Mode D'emploi page 35

User manual
SPECIAL TIG WELDING PROCESSES
• Spot (Mode adjustable directly from the welding cycle)
This mode is for spot welding, which allows workpieces to be pre-assembled
prior to welding. Spot welding can be done manually using the trigger or timed
with a predefined spot welding period. Spot welding allows for better reproducibi-
lity and non-oxidised weld points.
Spot
VaL t.dC
welding time
(s)
• Multi-Spot (Mode adjustable directly from the welding cycle)
This is a spot welding mode similar to TIG Spot, but with defined tacking and hold
times, as long as the trigger is held down.
Spot
VaL t.dC
welding time
(s)
Duration
VaL t.MU.
between
2 points (s)
Translation of the original
instructions
The tacking time is in the welding cycle after the gas station.
Man t.dC
The tacking time is in the welding cycle after the gas station.
Man t.dC
0.1 t.MU.
KRYPTON 231 DC FV / 321 DC TRI / 401 DC TRI
SETUP
PRESS 3''
The grayed-out areas are not available in this mode.
60.0 t.dC
Validation of
the current
setting
SETUP
PRESS 3''
The grayed-out areas are not available in this mode.
60.0 t.dC
Validation of
the current
setting
25 t.MU.
Validation of
the current
setting
Weld
JOB
Weld
JOB
35