Télécharger Imprimer la page

Signature Kitchen Suite SKSIT3001GE Manuel Du Propriétaire page 17

Publicité

Les langues disponibles

Les langues disponibles

en-us_main.book.book Page 17 Wednesday, June 12, 2024 1:28 PM
If Cooktop is Used in a New Branch
Circuit Installation (1996 NEC), Mobile
Home, Recreational Vehicle, or where
Local Codes Do Not Permit Grounding
to the Neutral (White) Wire
Observe all governing codes and local ordinances.
1
Disconnect the power supply.
2
At the circuit breaker box, fuse box or junction
box, connect appliance and power supply
cable wires as shown.
WARNING
• If connecting to a 4-wire power supply cable
electrical system, the appliance frame connected
ground wire MUST NOT be connected to the
neutral wire of the 4-wire electrical system.
4-Wire Grounded Junction Box
Cable from Power Supply
a
Cable from Cooktop
b
Ground Wire
c
Red Wires
d
Green Wire (Ground)
e
UL-listed Conduit Connector
f
Black Wires
g
Junction Box
h
White Wire (No Connection)
i
Installing the Cooktop Unit
1
Visually inspect the cooktop for damage.
Make sure all cooktop screws are tight (see
below for locations).
3 Screws (Same Both Side)
a
3 Screws (Same Both Side)
b
2
Check and prepare the installation location.
• See Dimensions and Clearances.
3
Carefully lower the cooktop into the
countertop cutout, making sure not to trap
any wires.
NOTE
• Do not use caulking compound. The cooktop
must be removable, should service be required.
4
Attach the retainer brackets
of the cooktop; then snug the bolts against
the bottom of the countertop as shown.
INSTALLATION
17
to the bottom
a

Publicité

loading