Publicité
Les langues disponibles
Les langues disponibles
˜ Troubleshooting
To keep the warranty valid, never try to repair the product yourself . If you encounter problems when
using this product, check the following points before requesting service .
Problem
No power
Remote control does not
work
No response from the
product
Clock setting erased
I cannot find the Bluetooth
name of this product on
my Bluetooth device
The disc does not play
The product automatically
switches to standby mode
after 15 minutes
42 GB/IE
Cause / Solution
Ensure that the power cord 46 is properly connected .
Ensure that the mains switch is switched on and there is power
at the AC outlet .
Press the
button 6 or the
to turn the product on .
Before you press any playback control button: Select the correct
audio source .
Reduce the distance between the remote control and the
product .
Insert the batteries with their polarities (+/–) aligned correctly .
Replace the batteries .
Aim the remote control directly at the sensor (the sensor is
located on the front of the main unit) .
Disconnect and reconnect the power plug 46 . Turn the product
on again .
Power has been interrupted or the power cord 46 has been
disconnected .
Reset the clock .
Ensure the Bluetooth function is activated on your Bluetooth
device .
Re-pair the product with your Bluetooth device .
There is no disc inside the product (NO CD appears on the
display) .
Insert the disc correctly with the label side facing towards the
front .
Clean the disc .
PAUSE mode may be activated . Deactivate the mode .
A non-valid disc has been inserted .
Condensation may have formed inside the product due to a
sudden change in temperature . Wait about 1 hour for it to clear
and try again .
When the product's external input signal level is too low, the
product will turn off automatically in 15 minutes . Please increase
the volume level of your external device .
button 20 on the remote control
Publicité
