Starting up the device
Using the digital angle finder
Press the ON / OFF button
LCD display
Loosen the locking knob
clockwise.
= Direction of loosing the locking knob
Put the digital angle finder on a flat surface.
Make sure both rulers
surface (see Fig. C). Then, press ZERO button
to set data to zero.
Rotate the ruler to measure the angle.
Note: The locking knob
by turning it clockwise, so as to hold a desired
measured angle.
= Direction of tightening the locking knob
You may also open the 2 rulers 180° straight
aligned with the surface (see Fig. D), and then
press ZERO button
to measure the angle.
Tip: The display will show "Err", if the digital angle
finder has been turned over 360° (see Fig. E). Turn
back the digital angle finder to the original starting
point and measure again.
Tip: The LCD display
switch on while rotating the ruler
Tip: The LCD display
off after approx. 5 minutes to 6 minutes.
Troubleshooting
The product contains sensitive electronic components.
That is why it experiences interference when in
close proximity to radio transmission devices. If any
indication errors appear in the display, remove such
devices out of the proximity of the product.
Electrostatic discharge could result in malfunctions.
When such malfunctions occur, remove the
battery for a short while and re-insert.
12
GB/IE/NI
on.
3 ]
[
1 ]
[
to set zero. Rotate the ruler
6 ]
[
will also automatically
3 ]
[
automatically switches itself
3 ]
[
to switch the
[
5 ]
by turning it anti-
2 ]
[
are aligned with the
can be tightened
2 ]
[
.
1 ]
[
2 ]
[
.
6 ]
[
2 ]
[
.