Bosch 0.601.18P.703 Notice Originale page 19

18 | English
Control Indicator
The control indicator 12
flashes:
The power tool is operating
in the overload range.
Reduce the feed pressure. If
required, switch the ma-
chine off and sharpen the
core bit.
When the feed pressure is not reduced, the elec-
tronic control will reduce the speed, even to a
complete stop, if required. After the load is
freed, the machine automatically restarts again.
The control indicator 12
lights up continuously:
The carbon brushes must be
replaced.
A Bosch after-sales service
station will handle this main-
tenance task quickly and re-
liably.
Removing the Core
After drilling, continue to run the water for a
short period in order to flush out the drilling
sludge between the core bit and the core.
If the drilling core is stuck in the core bit, then
apply light blows onto the core bit with a piece
of soft wood or plastic in order to loosen the
core. If required, pry the drilling core out of the
core bit using an appropriate hand tool (slotted
screwdriver or similar).
Note: Do not hammer or apply blows onto the
core bit with hard objects (danger of deforma-
tion)!
1 609 929 W83 | (9.11.10)
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
Clean the drilling spindle 9 after finishing work.
Occasionally spray an anti-corrosion agent onto
the drilling spindle and the core bit 7.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
Accessories/Spare Parts
Diamond drill stand S 500 A . . . 0 601 190 025
Water collection ring . . . . . . . . . 2 609 390 389
Sealing lid for water
collection ring . . . . . . . . . . . . . . 2 609 390 391
Water-pressure container . . . . . 2 609 390 308
Sliding ring . . . . . . . . . . . . . . . . . 1 600 190 042
Extension, 300 mm:
– For G 1/2"core bit. . . . . . . . . 2 608 598 044
– For 1 1/4" UNC core bit . . . . 2 608 598 045
After-sales Service and Customer
Assistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer service representatives can an-
swer your questions concerning possible appli-
cations and adjustment of products and acces-
sories.
Bosch Power Tools