Reely ROAD 49 01 27 Notice D'emploi page 51

Setting front axle alignment:
The setting takes place by twisting the track rod (D). Due to the
left-hand/right-hand thread, the track rod does not have to be
removed for this purpose.
Depending on rotating direction, the toe in or toe out is set.
D
Instead of the track rod, you can also turn the ball-head screws
(A) and (B).
The outer metal grub crews (C) must not be turned since they
only fasten the ball-head screws in the axle spur.
A
C
For this, observe the description in chapter 10. a).
Setting toe-in:
Turn both ball-head screws (A) and (B) clockwise.
Setting toe-out:
Turn both ball-head screws (A) and (B) counter-clockwise.
B
C
Setting rear axle alignment:
The outer metal grub crews (C) must not be turned since they
only fasten the ball-head screws in the axle spur.
For this, observe the description in chapter 10. a).
Setting toe-in:
The ball-head screw (B) is turned clockwise, the ball-head screw
(A) is turned counter-clockwise.
Setting toe-out:
C
The ball-head screw (B), pointing towards the vehicle front must C
B
be turned counter-clockwise.
A
The ball-head screw (A) pointing towards the vehicle tail must
be turned clockwise.
51