Publicité
Les langues disponibles
Les langues disponibles
Working without the automatic
levelling system
Put the LOCK switch
Push and hold the ring-button
the product release two laser lines from the laser beam opening
that are not levelled. Operation without automatic levelling
6
will always be indicated via the red LED indicator
Push and hold the ring-button
switch off two laser lines from the laser beam opening at this mode.
Practical guidance
Always use only the middle of the laser line for markings. The
width of the line depends on the distance.
Working with the clamp
The clamp provided can be used to attach the device to various
objects.
1. Release the clamping nut
anti-clockwise.
2. Position the clamping jaws
3. Rotate the clamping nut
4. Place
-thread
the clamp and tighten with hand. Do not use excessive force as
this may damage the device.
34 GB/IE
into the position .
4
1
1
by rotating the clamping nut
10
to the desired location.
9
clockwise until fastened.
10
of cross line laser with the
5
on the top of the product until
on top again until the product
.
2
-screw
of
7
Publicité
