Parkside 331672 1907 Traduction Des Instructions D'origine page 33

To switch the product off, push the LOCK switch to the
4
position . When switched off, the pendulum unit is locked.
Use automatic levelling system
To work with automatic levelling, place the product on a level,
firm surface, or fasten it with the -thread to -screw
5 7
of supplied clamp.
When it is switched on, the automatic levelling system automat-
ically corrects irregularities of ±4° within the self levelling area.
The levelling is concluded when the laser lines stop moving and
the LED indicator goes green.
2
If automatic levelling is not possible, e.g. because the base of
the measuring tool deviates by more than 4° from the horizon-
tal or because the product is being freely hand-held, the LED
indicator will go red and the horizontal and vertical laser
2
lines will be switched off.
Note 1: operation without automatic levelling will always be
indicated via the red LED indicator .
2
Note 2: if the product is agitated or its position is changed
during operation, the product will automatically re-level. After
re-levelling check the positions of the horizontal and vertical
laser lines against reference points to avoid errors.
Note 3: The top Ring-button
has no function at this mode.
1
GB/IE 33