Publicité
Les langues disponibles
Les langues disponibles
■
Prepare only sufficient solution for the job in hand so that
nothing is left over.
■
Do not mix different chemicals unless such mixture is
approved by the manufacturer.
FILLING THE CONTAINER
■
Make sure that the container is completely emptied and
cleaned before a different chemical is filled in.
■
Remove the battery pack before filling the container.
Wipe off any spills before installing the battery pack.
■
Stand the product on a level surface, and do not fill the
container above the maximum mark.
■
When filling from the tap, do not immerse the end of
the hose in the chemical solution. Sudden low pressure
in the system may cause the chemical solution to be
sucked back into the water supply.
■
Before filling the container with solution, carry out a test
run with fresh water, and check all parts of the product
for leaks.
■
Make sure that the filler cap is properly closed after
filling.
■
Hang a tag on the product to note what chemical solution
is being used.
APPLICATION
■
The black filter installed in the fogger is best suited
for outdoor use to spray herbicides, insecticides, or
fungicides. The white filter is recommended for indoor
use to spray disinfectants or cleaning solutions. Certain
chemicals such as vinegar, soluble disinfectants, and
liquid copper fungicide may significantly increase the
risk of clogging or corrosion when using the white filter.
■
When using either filter, it is important to purge the fogger
every hour during use. Purging or cleaning instructions
can be found in this manual. Always clean the filter at
the end of each day of use. Never store anything in the
fogger.
■
Make sure that the filter, tube, and spring are assembled
tightly. The two tubes should be apart and not next to
each other when installed inside the fogger.
■
Never blow through nozzles or other components by
mouth.
■
Avoid contact with chemicals. Immediately change
clothing that are contaminated with chemicals.
■
Do not aim the nozzle towards persons, animals, and
electrical equipment.
■
Do not operate the product in windy conditions. Always
aim downwind.
■
Avoid using the product in freezing weather since the
solution may freeze.
■
To reduce the risk of accidents and damage to the
product, never operate the product with:
●
flammable liquids
●
viscous or sticky liquids
●
caustic or corrosive chemicals
●
liquids above room temperature
■
Clean the product after each use.
The product may be subject to national requirements for
regular inspection by designated bodies, as provided for in
Directive 2009/127/EC of the European Parliament and of
the Council of 21 October 2009 establishing a framework
for Community action to achieve the sustainable use of
pesticides.
ADDITIONAL BATTERY SAFETY WARNINGS
■
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse the tool,
battery pack, or charger in fluid or allow fluid to flow
inside them. Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and bleach or
bleach-containing products, etc., can cause a short
circuit.
■
Charge the battery pack in a location where the ambient
temperature is between 10 °C and 38 °C.
■
Store the battery pack in a location where the ambient
temperature is between 0 °C and 20 °C.
■
Use the battery pack in a location where the ambient
temperature is between 0 °C and 40 °C.
MAINTENANCE
■
Use only original manufacturer's replacement parts,
accessories, and attachments. Failure to do so can cause
possible injury, can contribute to poor performance, and
may void your warranty.
■
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. Have the product serviced by an authorised
service centre only.
■
To avoid serious personal injury, always remove
the battery pack from the product when cleaning or
performing any maintenance.
■
After each use, check all parts of the product for leaks.
Return the product to an authorised service centre for
repair if necessary.
■
You may make adjustments or repairs that are described
in this manual. For other repairs, contact an authorised
service centre.
CLEANING THE REFILLABLE CONTAINER
Drain all chemical solutions from the refi llable container
into a container approved for chemicals. Do not store the
chemicals in the refi llable container. Use clean water to
clean and rinse the refi llable container. A small amount
of mild household detergent may be added. It may be
necessary to rinse the refi llable container more than once.
CLEANING THE PRODUCT
■
Do not use flammable solvents or abrasive cleaning
agents to clean the product.
■
Fill the tank about one-third full with clean water. A small
amount of mild household detergent may be added.
■
Spray into a suitable container until the tank has been
emptied.
■
Refill and repeat the procedure with clean water. It may
be necessary to rinse the tank more than once, then
drain again as directed above.
■
Allow all parts to completely dry, then reinstall the tank
cap.
■
Wipe the outside of the fogger with a clean, dry cloth.
5
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
Publicité
