Publicité
Les langues disponibles
Les langues disponibles
(2) Slide the nail strip forward in the magazine.
(3) Pull the feeder knob back to engage the nail feeder
(B) to the nail strip.
Nail feeder (B)
NOTE:
● Quietly set the nail feeder (B) and feeder knob against
the nail.
If the nail feeder (B) and feeder knob are released
from backward the magazine and bumped against
the nail, the connecting paper or plastic of the nail
can be damaged.
● Use nail strip of more than 10 nails.
● Use an unbroken nail strip with nails of all the same
length.
The Nailer is now ready to operate.
Removing the nails:
Pull the feeder knob backward.
Return the feeder knob forward quietly while pushing
the nail feeder (B).
Pull out nails from the back of the magazine.
Feeder knob
Feeder knob
Nail feeder (B)
NAILER OPERATION
Read section titled "SAFETY" (pages 3–10).
● Operators
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
● NEVER point tool at yourself or
others in work area.
● Keep fi ngers AWAY from trigger
when not driving nails to avoid
accidental fi ring.
● Do not use the electrical cord if damaged.
Have it repaired immediately.
● Choice of triggering method is important.
Please read and understand "METHODS OF
OPERATION" found below.
● Before starting work, check the nailing
operation switching device.
This metabo HPT nailer includes a nailing
operation switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
nailer will not operate correctly.
● Never place your face, hands or feet near
fi ring head when using.
● Do not drive nails on top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and
hit someone.
English
Nails
DANGER
and
others
WARNING
in
23
Publicité
