SilverCrest SFW 350 E5 Mode D'emploi page 11

Assembling the kubbe attachment
Unfold the fold-out side. There you will find the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing 6 as described under "Assembling the
meat grinder".
2) Disassemble any attachments that might be fitted and clean the meat grinder
casing 6.
NOTICE
To use the kubbe attachment r, neither the cross blade 9 with the spring 8,
►
nor a cutting or sausage disc 0/e are required! Remove these from the
meat grinder casing 6 if necessary.
3) Coat all metal parts with cooking oil.
4) Insert the two plastic parts of the kubbe attachment r so that the fixings on
the bottom kubbe attachment r ring are located in the openings in the meat
grinder casing 6.
5) When everything has been attached correctly, screw the ring clamp q back
on hand-tight.
6) Assemble the meat grinder casing 6 as described under "Assembling the
meat grinder".
Assembling the biscuit attachments
Unfold the fold-out side. There you will find the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing 6 as described under "Assembling the
meat grinder".
2) Disassemble any attachments that might be fitted and clean the meat grinder
casing 6.
NOTICE
To use the biscuit attachment 1, neither the cross blade 9 with the spring 8,
►
nor a cutting or sausage disc 0/e are required! Remove these from the
meat grinder casing 6 if necessary.
3) Coat all metal parts with cooking oil.
4) Pull the pattern strips 1 away from the front of the biscuit attachment 1.
5) First place the plastic disc and then the metal disc of the biscuit attachment 1
into the meat grinder casing 6 (see fold-out side). Insert the biscuit attach-
ment 1. so that the fixings on the biscuit attachment 1. are located in the
openings in the meat grinder casing 6.
6) After everything has been correctly assembled, screw the ring clamp q
back on hand-tight.
│ GB │ IE
■ 8
SFW 350 E5