Publicité
can be deformed by heat. Make sure there is 120 cm of free space in front of the fan heater and
50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on shelves), level
(since the appliance could tip over) and heat resistant.
Use
The fan heater is equipped with electronic controls for regulation and programming: Panel with
touch keyboard, remote control, and through the Smartphone APP.
- Control panel.
The panel is on the top of the fan heater, it has a touch keyboard, a display and
backlit symbols that show each operation in use. Below there's the list of functions:
O/I switch. It's back part, it switches on (pos. I) or switches off (pos. 0) the appliance.
Standby/OFF
The key (ON) switche on the appliance or puts it in standby.
-Note: the last selected mode is activated
Heating Mode
When "ON", the key selects the following modes one after the other: Hi -> Low -> Eco.
HI=2000W= very hot air
LO=1000W= hot air
"ECO": depending on the difference between the set and room temperatures (∆T), the
programme activates the HI (2000W) or LO (1000W) power or the fan only. When the
temperature set is: (∆T) > 4°C degrees from the room temperature, the HI function is
activated; 4°C > (∆T) > 2°C degrees from the room temperature, the LO function is
activated; (∆T) < 4°C degrees from the room temperature, the fan function is
activated. Once the required temperature has been reached, ventilation only
continues for a few seconds and then switches off.
Furthermore, if the key is pressed for 3 seconds, the Right-Left automatic swing is
activated and/or deactivated.
Temperature and Time Setting.
convection heater switched on, adjust the room temperature (5 - 45°C) with the two
keys, and once the value is reached the thermostat will interrupt the heating. When the
temperature decreases, the thermostat will turn the resistance back on for the time
necessary to restore the value.
Timer.
Once it expires the convection heater will go into Standby. The time can be adjusted
from 1h to 24h using the keys
seconds to put it in standby.
NOTE. The timer is subject to programming (daily/weekly) carried out via the APP: if
this is in progress, suspend it for the period in which the timer will be active.
Wi-Fi Key
Once the Wi-Fi configuration has been performed (see below), the functions of the
convection heater and the weekly programming can be controlled with the
smartphone and the "Bimar Live Smart" APP.
The key
Some functions are manageable with the Alexa and Google Assistant voice control.
In the "ON " state, the
activates the Reset of the Wi-Fi configuration.
Key
diminishes, key
key activates the Timer and its "Countdown".
. To reset the Timer, press the button for about 3
20
increases. With the
Publicité
