Publicité
Control panel
The appliance is equipped also these functions:
- Auto Dim. It darkens the display if you don't perform any operation within 1 minute of switching it
on: touching any key turns the display back on.
- Anti-tip switch. In the event of tipping over, it deactivates the device.
- Acoustic warning: an acoustic signal is emitted for each key selection
- Remote
In addition to the control panel, the convection heater is equipped with a remote control for
controlling the functions described on the side: it must be pointed (upper side) towards the control
panel, within a 4m distance making a 20 degrees angle.
The remote control is powered only by (one) CR2025 button coin cell battery, which is not supplied.
To enter it follow the procedures and warnings described here:
Display/Symbols:
1.
HI/LO/ECO: High/Low/ECO Mode
2.
: Set Temperature/Timer
3.
: Flashes if set temperature is reached
4.
: Auto OFF Timer
5.
: Power Indicator
6.
: WiFi Indicator
1.
ON/Standby
2.
Heating Mode
3.
Decrease the Temperature
4.
Increase the Temperature
5.
Auto OFF Timer
6.
Oscillation
1. Press the lock button and hold it down
to take out the battery holder.
2. Replace the battery with one of the
same type, making sure the (+) polarity is
facing up.
3. Push the battery holder in, until it's
locked in place securely.
21
Publicité
