Publicité
Les langues disponibles
Les langues disponibles
Preparation / Preparing the product for use
of the material is determined by the individual local
conditions.
- Screwdriver
Preparing the product for use
Assembling the lamp
Note: You will require a second person to help
with the assembly of the product.
Note: Place the floodlight on a soft surface (i.e. a
blanket) during assembly to prevent it from being
damaged.
Note: Please ensure that you pull the cable slowly
through the base during fitting.
Remove the transport locks
Connect the sections of tube
place.
Note: Be sure to screw in the section of tube
as far in as possible to ensure the light is stable.
Make sure that the mains cable
through the tube
7
Note: The nut
12
are pre-assembled on the upright tube
Remove the nut
12
from the upright tube
Remove the nut
12
the power cord
.
18
Insert the power cord
the middle of the base
First slide the securing plate (oval)
washer (large)
and finally the nut
20
the power cable
18
Then pass the power cord
the opening on the side of the base
Insert the upright tube
on the base
.
11
Make sure that the power cable
through the upright tube
Slide the securing plate (oval)
(large)
onto the upright tube
20
Tighten the nut
on the bottom of the base
12
using the tool
.
13
Ensure it is in the correct position.
20 GB/IE
from the tube
15
and screw in
7
running
18
does not get trapped.
and the washer (large)
.
7
and the washer (large)
20
.
7
and washer (large)
from
20
through the opening in
18
.
11
, then the
19
over
12
.
outwards through
18
.
11
through the opening
7
, which runs
18
, does not get jammed.
7
and the washer
19
from below.
7
Note: Be sure to hold the tube
tightening the nut
Note: Ensure the cable is inside the designated
opening in the base
Position the uplight upright.
Place the lamp glass
head
.
4
Affix the lamp glass
and washers
Fig. A).
Mount the bracket
to the tube
Connect the mains cable
adapter
14
Plug the plug-in mains adapter
perly installed socket.
Your light is now ready for operation.
.
7
Inserting / replacing batteries
7
Slide the battery compartment out of the remote
control
.
8
Insert the batteries included in the scope of
delivery into the remote control
20
Only use batteries specified in the chapter
„Technical Data".
Note: The correct polarity is indicated in the
battery compartment.
Slide the battery compartment back into the
remote control
If the range of the remote control
the battery needs to be replaced.
Slide the battery compartment out of the remote
control.
Remove the batteries.
Insert new batteries. Proceed as described
above.
Switching the light on / off
Use the ON / OFF switch
uplighter floor lamp on or off.
11
Switch the reading light
ON / OFF switch
7
.
12
so it cannot be pinched.
11
on the uplighter
3
using the screws
3
to the uplighter head
2
using the two screws
9
(see Fig. C).
7
to the plug-in mains
18
.
into a pro-
14
8
.
8
8
to switch the
17
on or off using the
5
.
16
tight when
1
(see
4
10
(see Fig. B).
reduces,
Publicité
