Publicité
Les langues disponibles
Les langues disponibles
5. INSTALLING THE LID HANDLE
Parts Required:
Lid Handle (#13)
1
x
2
x
Lid Handle Bezel (#14)
Installation:
•
Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a bezel on the
screw, then hand-tighten the screw (from the inside) into the lid handle.
•
Repeat same installation for other end of lid handle.
6. INSTALLING THE THERMOMETER
Parts Required:
1
x
Thermometer (#11)
Installation:
•
Remove the pre-installed nut from the thermometer. Insert the
thermometer into the hole provided on the top of the lid on the main
barrel, then secure by re-installing the nut from the inside. Rotate the
thermometer so the text is level and upright.
NOTE: If rotation is askew, this will result in incorrect readings.
7. ASSEMBLING THE SIDE SHELF
Parts Required:
Side Shelf (#12)
1
x
Tool Hook (#D)
3
x
Installation:
•
Turn the side shelf upside down. On the edge of the side shelf with three
holes, install the tool hooks into each hole along the edge. Tool hooks will
secure to the self-clinching nut that is pre-mounted on the inside.
8. MOUNTING THE SIDE SHELF
Parts Required:
Screw (#A)
4
x
4
x
Locking Washer (#C)
4
x
Washer (#B)
Installation:
•
From underneath, fasten the side shelf to the side panel of the main
barrel using four screws, locking washers, and washers.
NOTE: Do not tighten screws completely until all screws have been
installed. Once all screws are installed, then tighten securely.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not
covered by warranty.
5
14
13
6
11
7
12
D
8
14
D
D
A
C
B
9
Publicité
