Parkside Performance PKHAP 20-Li A1 Traduction Des Instructions D'origine page 26

Before use
Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack
to the charger.
■ Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket. The control
LED lights up red to indicate that the appli-
ance is charging.
♦ The green LED indicates that the charging
process is complete and the battery pack
ready.
♦ Push the battery pack
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦ Push the rotation direction switch
middle position (lock).
Allow the battery pack
handle.
Removing the battery pack:
♦ Press the release button
battery pack .
Checking the battery charge level
♦ Press the battery charge level button
check the charge level of the battery.
The status/remaining charge will be shown on
the battery display LED
♦ RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
PKHAP 20-Li A1
from or connect it
when the
to the high-speed
(see fig. A).
into the appliance.
into the
to click into the
and remove the
to
as follows:
Use
Additional handle
NOTE
► For safety reasons, you should never use this
appliance without the additional handle
attached.
♦ Remove the additional handle
a clockwise direction (see fold-out page).
♦ Turn the additional handle
position.
♦ Fix the additional handle
by turning it anticlockwise.
Depth stop
♦ Push the locking button for the depth stop
is
and keep it pushed in.
♦ Insert the depth stop
handle .
♦ Ensure that the toothing on the depth stop
facing downwards.
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
♦ Release the locking button for the depth stop
to lock the depth stop.
Tool/chuck:
♦ Place the tool in the tool holder
rotates until it locks automatically.
♦ Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
Removing a tool:
♦ Pull the locking collar
remove the tool.
by turning it in
to the desired
in the new position
into the additional
out until the distance
so that it
backwards and
GB │ IE │
21
is
■