Publicité
Les langues disponibles
Les langues disponibles
GB
IE
Operating Instructions
The vacuuming of glowing
embers and of materials that
are combustible, explosive or
harmful to health is prohib-
ited. There is a risk of injury!
•
Place the equipment on a level surface
that is not heat sensitive.
•
Always use the suction tube (16) for
vacuuming. In case of minor contamina-
tion, hold the suction tube (16) approx.
1 cm above the ash. Remove large ash
volumes by directly immersing the suc-
tion pipe.
•
Vacuum only cooled ash at less than
40°C.
•
When vacuuming, keep checking the
metal container (13) and suction hose
(15) for rises in temperature.
•
In the event of a rise in temperature,
switch off the equipment and discon-
nect at the plug. Place the equipment
outside and monitor it as it cools.
•
During breaks, you can insert the
suction pipe (16) into the holder (2)
on the container cover (10) or into an
attachment port on one of the rollers
(14).
•
Always use the carry handle (5) for
transporting the equipment.
•
The metal container (13) may be filled
to no more than half, so the pleated
filter (18) always remains clear.
•
Empty the container outside in order to
avoid mess (see "cleaning/maintenance").
•
Clean the pleated filter (18)
(see "Cleaning/Maintenance"):
- if suction power declines
- if the inspection window on the con-
tainer lid of the blockage indication
system (7) turns red.
22
Filter cleaning switch
Insert the mains plug of the device
and turn the device on.
If the suction power decreases, you can
improve it by pressing the filter cleaning
switch (3)
1. Turn the machine on.
2. Close the suction opening of the suction
pipe/suction hose (16/15) by hand.
3. Press the switch (3)
downwards to unlock.
Keep the switch pressed
and turn it 70° clockwise
until you hear a clicking
sound.
4. Now release the switch.
Repeat the procedure three times.
Cleaning/Maintenance
Pull out the mains plug.
Danger of electric shock.
Do not spray down the container
cover (
10) with water. Do not
use abrasive cleaning agents or
solvents to clean the device. The
device could become damaged.
General Cleaning Work
Clean the equipment after each use:
•
Carry out cleaning outside in order to
avoid mess.
•
Remove the container lid (10) and
empty the metal container (13).
Clean the metal container (13) with
water and allow it to dry.
Publicité
