Parkside PAS 1200 E4 Traduction Des Instructions D'origine page 20

GB IE
• Nozzles and suction tubes must
not reach head level whilst in
use. Personal injury could occur.
• Do not vacuum up substances or
dusts that are hot, glowing, com-
bustible, explosive or hazardous
to health (dust classes L, M, H).
This includes hot ashes, petrol,
solvents, acids or caustic solu-
tions. Personal injury could occur.
• Caution! Do not vacuum up haz-
ardous substances (e.g. petrol,
solvents, acids or lyes) and ash
from unauthorised fuels (e.g. from
oil-burning ovens or heating boil-
ers). There is a risk of injury.
• Do not vacuum up fine, combustible
dusts. There is a risk of explosion.
• Do not vacuum up hot ashes
and hot, glowing or combustible
objects (e.g. charcoal, ciga-
rettes...). There is a risk of fire.
• Do not vacuum up liquids, soot
or plaster and cement dust. You
could damage the equipment.
• The vacuum must not exceed a
temperature of 40°C. Vacuum
material that appears cool from
the outside may still be hot inside.
Hot vacuum material can re-ignite
in the air stream. Furthermore, the
equipment can be damaged.
In the event of a rise in tempera-
ture, switch off the equipment
and disconnect at the plug.
Place the equipment outside and
monitor it as it cools.
The following states how
damage to the appliance
and possible injury to people
can be avoided:
• Ensure that the equipment is as-
20
sembled correctly and the filter is
in the correct position.
• When vacuuming, do not place the
equipment on heat sensitive floors.
For safety reasons, use a fireproof
base when cleaning ovens, chim-
neys or barbecue equipment.
• Do not extinguish hot ash par-
ticles with water, as the sudden
temperature differences can
cause cracks in your chimney.
• Use only replacement parts and ac-
cessories supplied and recommend-
ed by our service centre. The use of
foreign parts will result in immediate
invalidation of the guarantee.
• Have repairs carried out only by
customer service points that we
have authorised.
• Observe the instructions for the
cleaning and maintenance of the
equipment.
• Empty and clean the vacuum
before and after vacuuming in
order to prevent the accumula-
tion in the vacuum of materials
that represent a fire load.
• Keep the equipment in a dry
place, out of reach of children.
Assembly
Disconnect at the plug before carry-
ing out any work on the equipment.
Risk of electric shock!
Reel assembly
Clip the three reels (
edge of the housing onto the relevant cur-
vatures. The curvatures are located on the
bottom of the housing
14) at the lower