Publicité
Les langues disponibles
Les langues disponibles
Vacuum mode:
Make sure that the collection bag (19) is
hooked in and connected.
1. Turn the rotary knob (10) completely
backwards to select "Suction" mode.
2. Adjust the working height by adjusting
the knob (13).
low working height = small radius
high working height = large radius
The brush only has contact
with the floor on the lowest
setting.
Emptying the collection
bag
The suction capacity is significantly redu-
ced when the collection bag is full. Empty
the collection bag when it is full or when
the suction power of the device decreases.
1. Turn off the device and wait until the
impeller has stopped.
2. Disconnect the device from the power
supply.
3. Open the cover (8).
4. Press the release button (9) and remove
the collection bag pipe (7) from the ma-
chine housing (14).
5. Carry the collection bag (19) by the
carrying handle (21).
6. Release the four retaining clips (3) and
remove the collection bag (19) from the
machine.
7. Open the zip (16) on the collection
bag (19) and empty it completely.
8. Re-mount the empty collection bag.
Composting material does not
belong with domestic waste!
Cleaning and
maintenance
Warning! Risk of injury by
dangerous moving parts!
Always clean the device
immediately after working with
it, as otherwise dirt will become
hardened and firmly attached
with leaf residues and might prove
impossible to remove without
dismantling the motor housing.
Such cleaning work is not covered
by the warranty.
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OeM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing and remove
the mains plug
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the device.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
Cleaning
Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
•
Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
GB
IE
29
Publicité
