Publicité
Les langues disponibles
Les langues disponibles
Warning! During operation,
this electric tool generates an
electromagnetic field which,
under certain circumstances,
may impair the functionality
of active or passive medical
implants. In order to reduce
the danger of serious or fatal
injuries, users who wear medi-
cal implants must consult their
doctor and the manufacturer
of the implant before opera-
ting the machine.
Initial start-up
Mounting handlebar
1. Unscrew the two screws (15) from the
lower bar (6) and place the lower bar
(6) in the machine housing (14).
2. Fasten the lower bar (6) with the two
screws (15).
3. Place the middle bars (5) on the lower
bar (6). Here you can vary the height
of the handle by choosing one of three
different positions.
4. Fix the middle bars (5) using the screws,
quick-release lock and washers (4). The
quick-release locks must point outwards.
The smooth side of the washer should
point towards the quick-release lever;
the grooved side should point towards
the bar.
5. Thread the cable strain relief (22) onto
the handlebar (1).
6. Fix the handlebar (1) using the screws,
quick-release lock and washers (4) to
the middle bars (5).
The smooth side of the washer should
point towards the quick-release lever;
the grooved side should point towards
the machine.
7. Clip the two cable holders (18) onto the
handlebar (1) or onto the lower bar (6).
8. Fasten the cable (20) to the handlebar
and lower bar using the cable holder
(18).
Mounting retaining clips
1. Place the retaining clips (3) with
straight edge into the holes on the
handlebar (1). The part to clip in must
point to the right.
2. Place the retaining clips (3) with slan-
ted edge into the holes on the middle
bars (5). The part to clip in must point
to the right.
Installing/removing the
collection bag
In suction mode the device
must only be operated with
the collection bag mounted.
The ventilation opening (25) on the
collection bag improves air circulation.
1. Insert the retaining clips (3) of the coll-
ection bag into each other. These will
allow you to attach the collection bag
(19) to the handlebar (1) and the midd-
le bars (5).
2. Unfold the cover (8) of the blowing
aperture.
3. Slide the collection bag pipe (7) onto
the opening of the motor housing until
it engages with the release button (9).
GB
IE
27
Publicité
