Parkside PLKSB 1800 A1 Traduction Des Instructions D'origine page 28

GB IE
Operation
Prior to each use, ensure
that the machine is working
correctly. Ensure that the
collection bag and pipe are
installed correctly.
Stop using the machine if the
On/Off button is damaged.
Personal protective equip-
ment and a fully functional
device reduce the risk of
injuries and accidents.
After the device has been
switched off, the impeller
continues moving for some
time. Injury hazard caused
by rotating tool!
Observe noise protection rules and
other local regulations.
D
Switching on and off
Ensure secure positioning.
1. Place the machine on a level surface.
2. Make a loop from the end of the exten-
sion cable and attach this to the cable
strain relief (22).
3. Connect the extension cable to the ma-
chine socket (24).
4. To switch on, press the switch lock (23)
on the handlebar (1) and then pull the
start handle (2) towards the handlebar.
Release the switch lock (23).
5. To switch off the machine, release the
start handle (2).
Working with the machine
The electric leaf vacuum
sweeper/blower may only
28
be used for the following
purposes:
- as a blower for clearing
paths, driveways,
- as a vacuum for vacu-
uming up dry foliage. The
machine also serves as a
shredder in suction mode.
The dry leaves are shred-
ded, their volume reduced
and prepared for possible
composting. The intensity
of the shredding depends
on the size of the leaves
and the residual moisture
they contain.
Any use, other than that
which is described above,
can damage the machine and
thus pose a risk to the user.
When working with the machine,
take care not to knock it against
hard objects that could cause
damage. Do not vacuum up solid
objects such as stones, branches or
branch cuttings, fir cones or similar,
as these could damage the machi-
ne, especially the shredding unit.
Repairs of this kind are not
covered by the warranty.
Selecting the operating
mode and setting the
working height
Blowing mode:
1. Turn the knob (10) completely forwards
to select the "blowing" mode.
2. Adjust the working height by adjusting
the knob (13).
low working height = small radius
high working height = large radius