Publicité
Les langues disponibles
Les langues disponibles
monoTIG 165ip / monoTIG 200ip
2.3 Mains Plug Connection
For your safety, never use the mains cable of the machine without a plug.
No plug has been connected to the mains cable since there may different types of outlets available in plants,
construction sites and workshops. A suitable plug must be connected by a qualified electrician. Make sure that
the grounding cable is present. After connecting the plug to the cable, do not attach it to the outlet at this stage.
2.4 Connection to Mains
When plugging the power plug into the outlet, make sure that the on/off switch is set to "0".
Support should be received from authorized persons (qualified electricians, etc.). Check the phase voltage before
connecting the machine to the mains. The plug must be plugged to the outlet once it is observed to be correct.
Turn the coarse on/off switch to position "1" to start the machine. Make sure that the indicators and LEDs on the
control panel are lit and the cooling fan is operating.
2.5 Connections for TIG Welding
Check for the correct mains voltage before connecting the machine to the mains.
When plugging the power plug into the outlet, make sure that the power switch is set to "0" in
• Start the machine with the on/off switch and check whether the LEDs are on and the cooling fan is working.
the turned-off position.
Tungsten Electrode
Recommended TIG
1.6
Diameter (mm)
Welding Current
2.0
2.4
• Insert the TIG torch's plug into the negative pole welding socket and tighten it by turning to the right. Attach the
2.5.1 Torch Connections
torch trigger connector that came with the machine to the trigger control cables of the torch. Then connect the
connector to the trigger control socket.
• Connect the gas hose of the torch to the gas outlet.
• Water cooling unit is an optional accessory for cooling the water cooled torches in demanding applications.
www.magmaweld.com
30-130
45-180
70-240
Installation
15
EN
USER MANUAL
Publicité
